REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 25
SERVICE MANUAL
FOOTPLATE DISTANCE
FOR “ZERO” FRAME
HEIGHT ADJUSTMENT EVERY 1.5cm
Remove the bolts
A
and their corresponding nuts and washers
B
.
Slide the footplate tube up or down until the necessary height.
Insert the bolts through the nearest holes and tighten.
Where present, it is possible to use the second hole
C
, too.
If necessary, you can adjust the height of the two independent footplates differently.
With one piece footplate, the two tube have, of course, to be adjusted at the same height.
The footplate tube can be either short (1) or long (2).
The short tube has two positionings for the adjustment support (RH and LH) in order to
reach short footplate distances.
The long tube has only one positioning for the adjustment support and it is design for longer
footplate distances.
The tubes for double footplates and one piece footplates are the same, but the adjustment
support is different.
To reach the shortest footplate distance, one can, both at original assembly or afterwards,
cut off the footplate. The dotted lines
D
in the pictures above show up to where you can cut
off the frame: just below the fork support (regardless its positioning).
It should be clear that the possible adjustment may then be limited.
The adjustment support is fixed to the tube with the bolt
E
on which a drop of strong lock
thread glued is spread. Should you need to change the position of the support (only short
tube), in order to unscrew the bolt, you may need to heat it first. When you assemble the
support, spread a drop of strong lock thread glue on it.
After adjustment, check that between the lower side of the footplate and the ground there is
at least 2 cm and that there is no interference between footplate and casters.
Rubber adaptor for round footplate tube on elliptical tube (from 2019).
The round footplate tube needs the adaptor
F
to fit the elliptical frame tube. The adaptor’s
hole is not centred, therefore, you have to pay attention to mounting right and let adaptors in
the same way.
1
2
In the former version, the foot-
plate tube (RH and LH), one size
only, has an integrated plastic
support.
DOUBLE FOOTPLATE
ONE PIECE
FOOTPLATE
1
2
E
F
C
A
20 mm
G
TUB
E
TUB
E
20 mm
fixing
A
fixing
C
A
C
B
D
