REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 30
SERVICE MANUAL
ONE PIECE FLIP-UP CARBON FOOTPLATE
FOR JOKER “ZERO”
ANGLE ADJUSTMENT
Leave the footplate engaged in the using position.
With round tube
: loosen the bolt
A
of both adjustment supports.
With elliptical tube
: loosen the grab screw
A1
and the bolt
A
of both adjustment supports.
Turn the plate frontward or backward.
Once reached the correct inclination, tighten the bolt
A
on the lock side.
Check the footplate engages and disengages easily (you may need to make a minor angle
adjustment working on the plate) and then tighten the bolt
A
of the rotation side
.
With elliptical tube
: tighten the grab screw
A1
of both supports.
Note: this kind of footplate allows for the plate to be turned 180°, therefore, before proceeding
with the adjustment, raise the plate from the lock side and turn it until its rotation stops.
This rotation allows for a temporary opposite position of the plate, but it also helps to reduce
the encumbrance
if the plate, in its normal use, is positioned “external”.
To carry out such operation, just raise the plate from the lock support and turn it tp the opposi-
te position; then engage it to the lock support normally.
POSITIONING
2 positions: internal; external
REVERSING THE FOOTPLATE
1) Loosen the angle adjustment bolts
A
and slide off the lock and rotation sides supports
from the tube and assemble them reversing their position.
2) Or, remove the tubes, follow instructions of chapter
footplate distance
and assemble them
reversing their side.
Finally, adjust the inclinantion
and tighten the bolts
A
—
see also
“angle adjustment”
.
When reversing the footplate in either these two methods, you change the lock side, too.
Follows next page
A
A
11
INTERNA ESTERNA
A
Rotation side
Lock side
A
A1
A
with elliptical tube
