REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER 5
FRONT HEIGHT 2
Sliding the fork support
(not for version with swing away footplates)
SERVICE MANUAL
It is advisable to spread a
drop of mild lock thread
glue on the headless bolt
C
.
All the following fork supports are fixed to the frame with clamp system.
Once you loose the clamp, you can slide the support along the frame and change the front height.
Support with Spirit Level
Loosen the headless bolt
C
and the two nuts
B
.
Slide the support upward or downward to the desired
height.
Check that the two bolts
A
are fully tightened.
There must not be any room between clamp and plate.
Fix the two nuts
D
holding the bolt
A
and screw the
headless bolt
G
.
Repeat the same operations on the other side making
sure the height is the same. The two front wheels must
be touching the ground.
V-Design and V-Design 2.0 supports
Loosen the two bolts
A
and slide the support upward or
downward to the desired height.
Fix the two bolts
A
hard
.
If, after loosening the two bolts the support is too hard
to move, remove the bolts, screw them from the inner
side of the support, put and hold a little plate or washer
between the two inner walls of the support and screw
each bolt in order to expand the clamp.
If the frame is in carbon fibre, you will
see a little spacer (one on the upper side
and another on the lower side) within the
clamp. That is vital to avoid tightening
the clamp to the extent of cracking the
carbon fibre tube.
Never remove the spacers.
B
C
Remember that the front height adjustment can affect the seat inclina-
tion, so it is necessary to check and adjust the fork angle.
Expanding the clamp
clamp
V-DESIGN V-DESIGN 2.0
clamp
plate
SUPPORT WITH SPIRIT LEVEL V-DESIGN SUPPORT V-DESIGN 2.0 SUPPORT
A
A
A
