User manual |4-20 mA Pulsed Signal TransmitterA
·
3
Configuration
The transmitters are generally configured at the factory. However,
it is possible to make consultations or configurations by using
a “Module Reader,” consisting of a screen and four keys that are
connected to the transmitter through the only visible connector
inside.
Press the key to enter the main menu.
With the - and + keys, you can change the options within
the menu. With the key, you can enter the selected menu
option. With the c c key, the previous hierarchy.
Within the main menu, you can see the following options:
• Consultation
• Configuration
+
-
c c
Transmitter
power supply
+ 12 Vdc
- 0 V
Surface
fastening hole
Surface fastening
hole
1, 2, and 3
current outputs
2
3
Pulsed signal 2
CR (common)
Pulsed signal 1
Pulsed signal 3
CR (common)
1
12v
0v
You must connect the 0V of the transmitter to the 0V of the converter. It is
recommended that you use a shielded cable (with the grid connected to the
grounding wire) for cables that go to the converter (current and 0V outputs).
NOTE
Connecting