6.
Outlet box
Canopy cover
Canopy
Mounting
bracket
Figure 10
Screws
Finishing the Installation
Step 1.
Tuck connections neatly into ceiling outlet
box.
Step 2.
Slide the canopy up to mounting bracket and
place the key hole on the canopy over the screw on
the mounting bracket, turn canopy until it locks in
place at the narrow section of the key holes. (Fig.
10)
Step 3.
Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the mounting bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
it drops into place.
INSTALLATION OF
SAFETY SUPPORT
Figure 9
Secure safety cable to the building structure
with a wood screw. (wood screw not supplied)
(Fig. 9)
Mounting bracket
Safety cable
