Progress Lighting AirPro P250003, Installation Manual

Figure 8

Figure 9

Hanging the Fan

REMEMBER to turn off the power. Follow 

the steps below to hang your fan properly.
NOTE: This fan is recommended for 

standard ceiling mount using the downrod 

provided with this fan. When using standard 

ceiling fan installation with the 6 inch 

downrod provided, the distance from the 

ceiling to the bottom of the fan blades will be 

approximately 13 inches.

Standard Ceiling Mounting

1.  Remove the canopy ring from the canopy 

by turning the ring to the right until it 

unlocks. (Figure 8)

2.  Remove the mounting plate from the 

canopy by loosening the four screws on 

the top of the canopy. Remove the two 

non-slotted screws and loosen the slotted 

screws. This will enable you to remove 

the mounting plate. (Figure 9)

3.  Remove the hanger pin and locking pin 

from downrod assembly.

4.  Route the wires exiting the top of the fan 

motor through the decorative motor collar 

cover then the canopy ring. Make sure the 

slot openings are on top. Route the wires 

through the canopy and then through the 

ball/downrod assembly. (Figure 10)

5.  Loosen, but do not remove, the set screws 

on the collar on the top of the motor 

housing.

6.  Align the holes at the bottom of the 

downrod with the holes in the collar on 

top of the motor housing. (Figure 10 )

7.  Carefully insert the hanger pin through 

the holes in the collar and downrod. Be 

careful not to jam the hanger pin against 

the wiring inside the downrod. Insert the 

locking pin through the hole near the end 

of the bolt until it snaps into its locked 

position, as noted in the circle inset of 

Figure 10.

8.  Re-tighten the set screws on the collar on 

top of the motor housing.

9.  Make sure the grommet is properly 

installed in the collar cover, then slide 

the collar cover on the downrod until it 

rests on the motor housing. Be sure that 

the canopy and the collar cover are both 

oriented correctly.

10. Proceed to “Installing the Fan” section.

FAILURE TO PROPERLY INSTALL SET SCREWS 

AS NOTED IN STEP 8 COULD RESULT IN FAN 

LOOSENING AND POSSIBLY FALLING.

Turn Canopy to Remove

Motor collar

Pin in locked

position

Locking pin

Tighten

screws

Hanger pin

Motor collar

cover

Canopy ring

Motor wires

Ball/Downrod

assembly

Canopy

Figure 10

Motor collar

Pin in locked

position

Locking pin

Tighten

screws

Hanger pin

Motor collar

cover

Canopy ring

Motor wires

Ball/Downrod

assembly

Canopy

5.