Progress Lighting AirPro P250003, Installation Manual

6.

Installing Fan to

the Electrical Box

1.  Pass the 120-volt supply wires through the 

center hole in the ceiling mounting bracket 

as shown in Figure 11.

2.  Install the ceiling mounting bracket on the 

electrical box by using the mounting screws 

provided with the electrical box. Note that 

the  flat  side  of  the  mounting  bracket  is 

toward the electrical box. (Figure 11)

3.  Tighten the two screws on the electrical box 

securely.

4.  Carefully  lift  the  fan  assembly  up  to  the 

ceiling mounting bracket. Make sure the tab 

on the mounting bracket is properly seated 

in the groove in the hanger ball. (Figure 12)

WHEN USING THE STANDARD BALL/DOWNROD 

MOUNTING, THE TAB IN THE RING AT THE 

BOTTOM OF THE MOUNTING BRACKET MUST 

REST IN THE GROOVE OF THE HANGER BALL. 

FAILURE TO PROPERLY SEAT THE TAB IN THE 

GROOVE COULD CAUSE DAMAGE TO WIRING.

UL Listed

Electrical

Box

Ceiling

Mounting

Bracket

Hook

120V Wires

Washers

Mounting

Screws

(Supplied with

Electrical Box)

Figure 11

Standard mounting

Figure 12

Connecting the Safety 

Cable

1.  Turn  the  wood  screw  (LL)(not  provided) 

into the ceiling.

2.  Place the looped end of the safety cable (S) 

onto the wood screw and then tighten the 

screw  firmly,  or  connect  the  safety  cable 

directly to the electrical box. (Figure 13)

S

LL

Figure 13