TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem
Possible cause
Remedy
You cannot activate or oper‐
ate the hob.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
The fuse is blown.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
You do not set the heat set‐
ting for 10 seconds.
Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more sen‐
sor fields at the same time.
Touch only one sensor field.
There is water or fat stains
on the control panel.
Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
You put something on one
or more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates.
You put something on the
sensor field .
Remove the object from the
sensor field.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
comes on.
Automatic Switch Off oper‐
ates.
Deactivate the hob and acti‐
vate it again.
comes on.
Child Safety Device oper‐
ates.
Refer to "Daily use".
Progress 11
Summary of Contents for PAS6001E
Page 57: ...Progress 57 ...
Page 58: ...58 Progress ...
Page 59: ...Progress 59 ...
Page 60: ...www progress hausgeraete de 867350955 A 212019 ...