Prolights Tribe SUNRISE4, User Manual

SUNRISE4

8

3.4 AUTO SHOW MODE

If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-

gramme provided that the blackout mode is switched off:

•  Press the button MENU so many times until the display shows 

Auto Show,

 then press the button ENTER.

•  Press the button UP/DOWN to switch between the show (

Auto 1 - Auto 6

). The unit will operate in show 

mode.

•  Using the button UP/DOWN to select the desired run speed slow-fast 

0-100 

•  Press the button ENTER to save the setting.

IMPORTANT: Programs 

Auto 1 - Auto 6

 are fully pre-programmed and will not be altered by changes. 

3.5 STATIC MODE

This fixture has the ability to accept custom static color settings. Access this via the control panel.

•  To enable the static mode, press MENU repeatedly until 

Static 

shows on the display.

•  Through the button UP/DOWN select 

Dimmer 

or 

Strobe 

then press the button ENTER.

•  Set the value (

000 - 255

), through the buttons UP/DOWN.

•  Press the button ENTER to confirm.

•  Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the 

Master. The unit must be the first unit in line; other units will work as slave with the same effect.

•  Press the button MENU so many times until the display shows 

Master/Slave 

and press the button ENTER.

•  Press UP/DOWN to set the unit as master or slave 

(Master, Slave)

.

•  Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the 

units. For longer cable runs we suggest a terminator at the last fixture (see page 11).

3.7 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the 

master unit.

1.  Connect the DMX OUT of the master unit via 3/5-pole XLR cable to the DMX IN of the first slave unit.

2.  Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units 

are connected in a chain.

3.8 DMX CONFIGURATION

SUNRISE4 is equipped with different DMX configuration. 

•  Press the button MENU so many times until shows 

DMX Channel,

 and press the button ENTER to confirm.

•  Select the desired DMX configuration (

4CH - 6CH - 9CH

) through the buttons UP/DOWN.

The tables on page 12 indicate the operating mode and DMX value. The SUNRISE4 is equipped with 3/5-

pole XLR connections.

3.9 DMX MODE

•  Press the button MENU so many times until the display shows 

DMX Address,

 and press the button ENTER 

to confirm.

•  Press UP/DOWN button to select the desired value (

001-512

). Press and hold to scroll quickly.

•  Press ENTER button to store.