DIAMOND37
12
3.4 SLAVE RECEIVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 differ-
ent Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous
loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was as-
signed to.
For example, if a slave device is set to Receive Part 1, the Master unit Slave unit will send the automated
Chase Part 1; if set to Receive Part 2, the Chase Part 2 Slave units will receive from the Master.
To set the drive as a slave, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
Program
icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and then select
Play
and press the ENTER
button to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and select
Slave Receive
and press ENTER to
confirm.
• Press the UP/DOWN button to select the different modes of operation
Part 1 Receive/Receive Part 2/Part 3
Receive
, and then press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
Select the desired program on the master unit (described in section 3.5).
Use the DMX connectors of the DIAMOND37 and an XLR cable to form a chain of units. Under certain
conditions and lengths you want to make a termination as shown on page 17.
3.5 OPERATIONS IN AUTOMATIC MODE
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
Program
icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Play
and press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Sequence
and press ENTER to confirm
your choice.
• Press the UP/DOWN button to select the mode of operation:
-
Master
, if the unit is connected in series with other units and it acts as the Master;
-
Alone
, if the unit is not connected to other units.
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.
Select Chase
The function
Select Chase
lets you choose the automatic program to actually run.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
Program
icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Select Chase
and press the ENTER button
to enter the next menu.
Summary of Contents for DIAMOND37
Page 1: ...USER MANUAL MANUALE UTENTE DIAMOND37 MOVING HEAD EN IT ...
Page 66: ......
Page 67: ......
