SPIRIT
8
Timer operation
In the timer mode, the fog machine will automatically emit fog. The time intervals, duration and fog vol-
ume depend on the corresponding menu settings. Press the button
[TIMER]
, to activate the timer mode.
The display indicates the set time interval. The unit counts down to 0 seconds and emits fog. To deactivate
the timer mode, press the button
[TIMER]
again.
Continuous operation
Press the button
[VOLUME]
, to activate continuous fog output. The display indicates »VOLUME« followed by
the value that was set in menu item »VOLUME OUT« or »NON STOP BURST« when continuous fog output
was selected. To stop the fog output, press the button
[VOLUME]
once again.
Four Volume settings:
•
NON STOP BURST - The machine will continue to output low fog, the volume is automatically adjusted
by the machine based on the working temperature.
•
HIGH VOLUME -- About 60% output volume.
•
MEDIUM VOLUME - About 52% output volume.
•
LOW VOLUME - About 35% output volume.
Manual operation
For immediate fog output at the maximum volume of fog, keep the button
[MANUAL]
pressed. The display
indicates »MANUAL OUTPUT«. As soon as you release the button, the fog output will stop. The manual
operation will take priority over the continuous operation and the timer operation. Even if one of these
operating modes is activated, the fog machine will always emit the maximum volume of fog when the
button
[MANUAL]
is pressed.
NOTE
•
After usage of the machine, please wait 15 minutes prior to turning off the machine.
•
Please do not turn the power on and off continuously. There must be at least one-minute interval time
between each power on and off.
•
Do not position 2 or more SPIRIT machines side by side to prevent poor hot air ventilation.
•
Do not operate the machine under direct sunlight.
•
It is strongly suggested not to make the machine to produce continuous fog output over 20 minutes.
Overtime usage might reduce the efficiency and lifespan of the compressor.
2.3 DMX SETTINGS
The SPIRIT machine is featured with built-in DMX 512 function and equipped with a 3-pin and a 5-pin
male-female connectors. When the machine is in use, either 3-pin or 5-pin connector can be selected to
connect to DMX controller. The SPIRIT only uses one control channel, the output value of each channel is
between 0-255. By using the same DMX system you are able to easily connecting fog generators, lighting
and other special effect machine to have a whole system performance.
CH Function in A channel mode
Value
A
VOLUME FOG OUTPUT
Off
Low Volume (35% output)
Medium Volume (52% output)
High Volume (60% output)
000 - 031
032 - 126
127 - 191
192 - 255
