SPLiTTER4WRK
4
1.4 OPERATING ELEMENTS AND CONNECTIONS
Fig.2
1. POWER SWITCH
This switch turns on and off the main power.
2. LINK OUT/TERMINATE SELECTOR
This switch is primarily meant for
troubleshooting. When the switch is in
“Terminate” position, DMX output is turned
off and you can not link any more units. When
the switch in the “Link Out” position, this unit
allows you link a second unit.
3. DMX IN (3 - pole XLR)
These connectors are used to receive an
incoming
DMX signal; 1=ground, 2=DMX-, 3=DMX+..
4. DMX OUT (3 - pole XLR)
These connectors are used for linking a
second unit;
1=ground, 2=DMX-, 3=DMX+.DMX IN (3-pole
XLR):
5. DMX OUTPUT
The four DMX output channels are completely
electronically isolated and each features an
independent driver that boost the DMX
signal.
6. FUSE
Always replace a fuse with one of the same
type
7. 230V ~ 50 Hz, main cable
Rear view
2
1
3
4
5
6
7
Front view
Summary of Contents for SPLITTER4WRK
