23
5. CLEANING AND MAINTENANCE
To dismantle the oven door
Tightening
latch
Recessed
support
1
2
3
To dismantle the oven door
Open the oven door (1).
Open the tightening latch up to the final
position (2).
Close the door until it is almost completely
closed as shown in the third diagram and
remove the door by pulling it.
Make sure that the embedded supports are
well positioned on the hinge support as shown in
the second diagram.
Reassembling the door is done
Make sure the
tightening latches are well refitted.
:
•
•
•
by reversing the
procedure explained above.
!
Cleaning gas burners
Remove enamelled
burner caps and
(Figure 14).
Clean them with soapy water
Rinse and dry with a soft cloth (do not leave them wet)
After cleaning, make sure that you re-assemble the parts correctly.
Do not clean any part of the cooktop with metal sponge. It causes the surface to be scratched.
The upper surfaces of
may deteriorate over time due to their use and the
burner flames. These parts will not get rusted and it is not a production fault.
When cleaning the cooktop plate, make sure that no water flows inside the burners to
the injectors.
•
•
•
•
•
•
•
grilles,
crowns
enamelled grilles
avoid
blocking
Downloaded from www.vandenborre.be