Dear Customer
:
Thank you for buying a Proline Refrigerator. To ensure that you get the best results
from your new refrigerator, please take time to read through the simple instructions in
this manual.
Please ensure that the packing material is disposed of in accordance with the current
environmental requirements.
Safety information
This information is provided in the interest of your safety. Please read the following
carefully before carrying out the installation or use of the refrigerator.
If you are discarding an old refrigerator / chiller with a lock/catch fitted.
Ensure that it is left in a safe condition with the lock / catch broken to prevent the
entrapment of children.
Old refrigerator equipment may contain CFC’s that will damage the ozone layer.
When disposing of any refrigerator equipment please contact your local waste
disposal department for advise on safe disposal.
This refrigerator must be only used for its intended purpose.
WARNING
This appliance is intended for domestic use only, any other use may invalidate the warranty
and might be dangerous.
Care must be taken that the coolant circuit must not be damaged at any time.
Installation
Position the refrigerator and allow to stand for two or three hours before it is turned
on for the first time to allow the system to settle. Do not position next to any heat
source e.g. cooker, boiler or in direct sunlight etc.
A clearance of 1
0
cm must be left between the sides of the appliance
and any adjacent cabinets or walls to allow for adequate air circulation.
This refrigerator is not designed for a recessed installation (“building in”)
.
Install on a good firm level surface, you can turn the front feet to stabalise any minor unevenness.
The refrigerator is heavy, carry the refrigerator by the casing not the door.
For purpose of safety all electrical repairs or maintenance must be carried out by a
qualified electrician or service agent.
Warning the plug must be accessible after the refrigerator is in position
This appliance is for refrigerating food
.
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid an electrical hazard.
