Operating your refrigerator
Before plugging in your refrigerator for the first time remove all packing, clean the
refrigerator with warm water and bicarbonate of soda. Wipe dry with a soft cloth.
Plug the refrigerator into the mains power supply ensuring that the voltage is the same
as the rating label and then turn the thermostat control knob that is situated at the
right
hand side of the
refrigerator
to the midway position. The compressor should then start.
Do not operate your refrigerator in a room where the temperature is likely to fall
below 1
6
degrees C
(61
degrees F
)
at night and /or especially in winter, as it is designed
to operate in ambient temperatures b1
6
to +32 degrees C at lower
temperatures the refrigerator may not operate, resulting in a reduction in the storage
life of the food.
Setting the temperature control
To control the internal temperature, adjust the thermostat control knob according to
the ambient temperature or purpose of use.
The temperature control knob has 7 setting from the coldest “7” to the warmest “1.
"0" is Off, ( 0 1,2,3,4,5,6,7).
Adjust the temperature control to the setting that best suites your needs normal
position 3 or 4.
Turning the control to the “0” position stops the cooling cycle, but does not turn off
the power to the refrigerator.
If the unit is unplugged, power lost, or turned off, you must wait 10 minutes before
restarting the refrigerator. If you attempt to restart before this time delay, the
refrigerator may not start.
Defrosting the Fridge
The fridge will defrost automatically, you must keep the drain hose clear, this is
located inside the fridge about two thirds down the back of the storage area on a shelf.
