7
E
n
g
li
sh
Synchronisation
1. Place the units close to each other.
2. Synchronisation will begin automatically once all batteries are in place.
3. The sensor is preset to channel 1.
4. The main unit will automatically display readings from channel 1 (if channel 1 does
not show, press [
▲
/CHANNEL] until channel 1 is displayed).
5. If the outdoor temperature shows (coming from the outdoor sensor) on the main
unit’s display, synchronisation is complete.
6. The units can now be placed at their desired locations.
Note:
Max range: 30 m.
Setting the sensor unit’s channels
1. Press [
▲
/CHANNEL] on the main unit until channel 2 appears (3).
2. Press and hold in [
▲
/CHANNEL] until the signal icon (4) begins to flash.
3. Open the sensor’s battery compartment.
4. Set the channel selector (36) to channel 2.
5. Observe the markings on the bottom of the battery compartment and insert
2 × AAA/LR03 batteries.
6. Refit the battery cover.
7. The readings from the sensor will appear on the main unit‘s display after
a few seconds.
8. Repeat the same procedure for setting the sensor to channel 3, if desired.
Operating instructions
Setting the time and date
1. Press and hold [SET/AL SET] for about 3 seconds until the year display flashes.
2. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired year.
3. Press [SET/AL SET] until the month display begins to flash.
4. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired month.
5. Press [SET/AL SET] until the date display begins to flash.
6. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired date.
7. Press [SET/AL SET], until the time zone begins to flash ”00” (see
Dual time zone
section below).
8. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired time zone.
00
= local time,
01
= +1 hour,
-01
= -1 hour etc.
9. Press [SET/AL SET] until “24hr” begins to flash.
10. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select a 12 or 24 hour time display.
11. Press [SET/AL SET] until the hours display begins to flash.
12. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired hour.
13. Press [SET/AL SET] until the minutes display begins to flash.
14. Press [
▲
/CHANNEL] or [
▼/
ºC/ºF] to select the desired minutes.
15. Press [SET/AL SET] or wait 10 seconds to return to normal time and date display.
Summary of Contents for IW004 36-5136
Page 2: ......
