8
English
Checks and installation
Note:
• The weather station has no on/off switch. It is operational as soon as
the batteries are inserted.
• The scan for signals from the sensors and the display of data from the sensors
occurs automatically as soon as the batteries have been inserted.
Mounting the main unit
• The main unit should be located indoors, away from any potential sources of
interference such as TVs and computers.
• Since the main unit contains a sensor for pressure, humidity and indoor
temperature, it should not be located too close to sources of heat such as
cookers or heaters/radiators. Neither should it be located in a place where it is
permanently exposed to direct sunlight.
• Fasten the main unit to a wall using the bracket on the back or stand it
on its table stand.
Mounting the rain gauge
Note:
The gauge is self-emptying but should be kept indoors at temperatures below
zero to prevent the water freezing and damaging it.
• Place the gauge in an open space at least 45 cm above the ground.
• Make sure that the gauge is placed on a level surface.
• Secure the gauge using 2 screws.
Dismantling the rain gauge for cleaning
1. Carefully remove
the grille using
a suitable object.
2. Carefully remove
the filter.
3. Lift out the sensor unit.
4. Re-assemble in reversed order. Make sure that
the sensor unit is correctly aligned. The metal pins
should fit into the holes and the little magnet should
be against the inside of the housing.
Magnet
