DRAFT
USER MANUAL
9
SPECIFICATIONS
•
Environment: -40 to 85 °C (-40 to 185 °F) non-condensing
•
RS485 Baud rates: 9600, 19200, 38400, 57600, 115200 (bps)
•
USB: 2.0
•
Battery: Lithium-Ion 3.7V
•
Antenna: Internal (PCB Trace)
•
RoHS
REGULATORY AND SAFETY NOTICES
Model Name: PL-485-BT
USA: FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference and
2.
This device must accept any interference, including interference that may cause undesired operation of
the device.
FCC Warning:
Changes or modifications not expressly approved by ProLon Inc. could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
FCC ID: 2AK9O-485BT20
