Prolyte H30V Rigging Tower
Assembly Instructions
Prolyte Products Group © 2001
page 1 of 9
Prolyte has made every effort to ensure the accuracy of this manual, no liability will be accepted for errors.
Prolyte reserves the right to change or alter their products or manuals without prior notice.
No part of this manual may be reproduced in any form or by any means without prior written permission.
Prolyte Products Group · phone: +31-594-851515 · fax: +31-594-851516 · www.prolyte.com
Make sure to read and fully understand this manual, and its specific notes and
warnings, prior to assembly and erection of the structure.
Contents:
1 System
Description
2
Limitations of use
3
Scope of use
4 Identification,
Parts
5
Dimensions & loading
6 General
information
7 Assembly
instructions
8 System
Dimensions
1. SYSTEM DESCRIPTION
The Prolyte H30V Rigging Tower is a lifting tool where the load is constrained by a horizontal and
vertical V-shaped truss frame. The H30V Rigging Tower has a loading capacity that is limited by the
construction. In general rigging towers are used where the lifting of loads from a building structure is
impossible, very expensive, or when traditional telescopic winch stands do not have a sufficient load
capacity, or when the MPT-Tower does not fit the purposes. This H30V rigging tower is used with a
vertical mast of standardized H30V truss as compression absorbing elements, H30V truss as
outriggers and a 60 mm tube as stabilizer brace.
2. LIMITATIONS OF USE
The H30V Rigging Tower is to be used with Prolyte trusses only. Loads to the trusses and towers shall
be vertical only, no side loading is allowed to the system, with an exception for wind loads. The
system may be used up to wind force 8 maximum.
The H30V Rigging Tower is designed as temporary lifting structure for in- and outdoor use. When
horizontal loading is applied, other than wind forces, appropriate measures, such as placing guy-
wires (cable-stays) and ballast, have to be taken to ensure stability.
The H30V Rigging Tower is to be built by competent and trained persons only. For all other
applications contact your local dealer or Prolyte.
3. SCOPE OF USE
Prolyte H30V Rigging Towers are designed for the lifting of speaker clusters or audience lights over
stages, dance floors, exhibition area’s, public area’s, parking lots, etc. This can either be a single (stand-
alone) Tower, or a Goal post configuration (two towers with a single span).
H30V rigging towers are to be built to a maximum height of 7,5m (7 metre mast length).
Prolyte- H30V Rigging Towers comply with the European Machine Directive and bear the CE-mark.
WARNING
Prolyte H30V Rigging Towers are not designed to lift people!
PROLYTE H30V RIGGING TOWER MANUAL
ASSEMBLY INSTRUCTIONS
