Slave(Remote) Mode(F1/F2)
The
F1
mode
is
used in a manual
flash
environment. The
F2
mode
is
used
in a TTL flash
environment
so as to ignore preflashes and properly fire in-sync.
However, the 100SL only functions as a manual flash without TTL exposure.
●
When the flash is in F1 mode, it will fire in-sync. with the master flash,
similar to a radio slave setup. To use this mode correctly, the master
speedlight should be set as a manual flash and the TTL flash system
with pre-flash and red-eye reduction modes should not be used.
Press the <MODE> button for 2
seconds to choose slave mode
starting with F1.
Set the flash output level.
●
Press the left/right
to decrease
/increase the flash output level.
●
The flash output level changes in
1/3 steps between 1/512 and 1/1.
Press and
hold
the
<
MODE
>
button
for
2 seconds
to
exit
F1
Slave
mode
.
buttons
●
●
When the speedlight is in F2 mode it will fire in-sync. but requires
power settings to be manually adjusted.
First
Then press the <MODE> button
again to choose F2 mode.
press the <MODE> button for 2
seconds to enter slave F1 mode.
Set the flash output level.
●
Press the left/right buttons to decrease
/increase the flash output level.
●
The flash output level changes
in 1/3 steps between 1/512 and
1/1.
Press and
hold
the
<
MODE
>
button
for
2
seconds
to
exit
F2
Slave
mode
.
F2 mode
F1 mode
Wireless Modes
16
