Multi-function Studio Flash
OWNER’S MANUAL
Safety Precautions:
1. Before using the flash, make sure that the electrical power supply matches the power requirements indicated on your lighting
equipment. Do not use any power other than the AC specification indicated on your equipment.
2. Do not expose your lighting equipment to sunshine, moisture, dust, dirt, rain, or water.
3. Any exposure to chemical solutions, gasoline, grease, oil, paint, or detergents can result in permanent damage to your
equipment.
4. Do not insert metal parts into any lighting equipment.
5. Dry your hands before handling the equipment. Touching your equipment with wet hands is dangerous to both the equipment and
to you.
6. To unplug your equipment, grasp only the plug. Do not unplug by pulling the electrical wire.
7. If your flash beeps continuously or does not function, turn your flash off and unplug for 30 seconds to reset.
8. Do not attempt to repair your lighting equipment. If a problem arises, contact the store from which you purchased the light.
Specifications:
Model
D200R – Code 7893
D400R – Code 7900
Power source
AC100
－
130V / 60Hz
Strobe output
200WS
400WS
Guide No. (ISO100)
45m
65m
Cooling fan
Built-in mini fan cooler
Power Range
1/32~1/1(5 steps) Continuously
Recycle time
0.5
－
1s
Flash duration
1/800
－
1/10000s
Beam angle
55 °
Slave sensitivity
10 m
Modeling lamp
150W / E27
Color temperature
5600K
Synch cord voltage
6V DC
Triggering
Synch cord/Test flash switch/Slave sensor/Integrated RF trigger
Fuse 10A
Housing size(mm)
136×127×320mm
Weight 2.2kg
2.5kg
Light Body &Rear Control Panel
-1-
16
15
14
13
14
13
9
2
4
5
6
11
12
3
10
9
Test
RF
Cell
Ready
Free/Prop
Buzz
Model
SYNC
POWER OFF
MODE
ON
1
8
7
17
18
