entering power saving mode. When the backlight is off, rotate either the
Control Wheel
or the
Volume Control
to restore the backlight.
2. In the process of searching stations under Seek Mode or Auto Program,
the system can only respond to the
Back Button
. If you want to quit
searching stations, please press the
Back Button
.
3. The RDS function only supports RDS information in English.
Battery Level, Charging and Indicators
The battery level status is shown by a battery symbol upon the normal screen.
Connect the supplied USB charging cable to a PC, or use power adapter
(option), to charge the iRadio.
When the USB battery charging commences, the power indicator glows
red
.
The battery can be charged during normal operation of the iRadio, however, if
the iRadio is operating and charging simultaneously, then the charge indicator
is
yellow
. When the battery is fully charged, the charge indicator goes out, or
turns
green
, if the radio is in use.
When the battery is running low, the battery icon flashes.
If the battery becomes critically low, the iRadio will power OFF automatically and
will not re-start until the battery is charged, or USB charging cable is applied.
NOTE:
The internal battery is NOT a user replaceable part and carries a 1 year
warranty.
37
Troubleshooting
If problems occur when connecting the radio to the wireless network, please try
as follows:
1. When scanning for a WiFi network and nothing is found, please make sure
your reception area has an effective WiFi network coverage.
2. When scanning for a WiFi network, the radio may prompt you that "You
connect too many APs, please delete one and scan again." This means you
have exceeded the limit of three stored networks in memory. Please remove
one network from the
Stored Networks
and then scan for networks again.
3. When you have scanned for a WiFi network but still can not connect to it,
please check whether the selected network is encrypted. If it is encrypted,
please select the correct encryption method and enter the correct key to gain
access.
If still not connected, please select the Automatic (DHCP) option in the Edit
Settings from the Network Menu and then try again;
If unable to connect to a WiFi network, please set to “Disable Power Saving” in
the Power Saving option from the Network Menu and try again;
If still unable to connect, please confirm whether the Wireless Network Access
Point has firewall and MAC address filtering, if so, please stop MAC address
filtering or add the device MAC address within the AP list of allowed addresses
and try again;
If still unable to connect, please check whether the Wireless Network Access
38
Promate(左对齐).indd 38-39
2009-12-9 8:52:42
