7/ TOOLS / BLADE HOLDER
2
– The blade must slighty overtake the blade holder. It shouldn’t exceed the vinyl
thickness and the liner to be cut. Be careful to respect this condition if you don’t want to
wear your blades.
NO
YES
NO
Vynil
Plastic base
1
– To install a blade on a blade holder, just press the metal stem located on the top (1) to
make bring out the blade (4) and be able to remove it. Make slip a new blade in the place
of the old one, side slicing downwards, then to screw/unscrew the cap (3) in a more or
less important way according to the blade going beyond which one wishes to obtain (4).
1/ Stem to remove the blade
2/ « Body » of the blade holder
3/ Adjustment of going
beyond of the blade
4/ Going beyond
of the blade
There are two blades for PROMACUT
:
-
: for thin material cuts
-
for thick
extra-thin cuts**.
45°blade
60°blade:
**The 60° blades are much sharper, thiner and
more fragile and require the respect of the r
blade overtaking adjustment mentioned above.
plotters
material or
ule of
45°
60°
09
PROMACUT PC-730E
info@promattexint.com - www.promattex-international.com
Address: 7 bis impasse Denis Dulac, 94700 MAISONS-ALFORT, FRANCE
Phone: 00 33 141 79 00 45 - Fax : 00 33 143 53 93 57
