9/ USE OF THE CONTROL PANEL:
1
– When the plotter is lit, it initializes then the screen
posts "On Line".
2
– The state "On Line" indicates that the plotter is ready to cut, all the keys of the
keyboard are then desactivated except the key "on Line" which allows to reach the many
settings available on the plotter.
10/ POINT OF ORIGIN:
1
– Press "On Line" so that the screen shows :
Move the blade thanks to the keys ( ,
,
&
) till the place desired for the beginning
of cutting knowing that the plotter cuts from the right to the left side.
Press on
to validate the point of origin: cutting will start exactly on the place where the
blade is, the screen shows again
Press "On Line" to be able to cut, the screen shows:
t p u q
Pease make the slider avoid touching the reset buttons.
"X=0.0 - Y=0.0".
±
11
PROMACUT PC-730E
info@promattexint.com - www.promattex-international.com
Address: 7 bis impasse Denis Dulac, 94700 MAISONS-ALFORT, FRANCE
Phone: 00 33 141 79 00 45 - Fax : 00 33 143 53 93 57
