5.6.7
Output Services
This window gives information about services to be released on the IPTV output.
Figure 14.
Select the IPTV outputs (from 1 to 10) to work on and then expand the data tree
to set the parameters in order to release services at the output:
LCNs Network identifier
: It is the number that identifies the network
where the signal is distributed.
Network name
: It is th
at identifies the network where the
signal is distributed.
e name th
Transport stream identifier
: It is a number that identifies a specific
transport stream.
Original network identifier
: It is a number that identifies the network
nal comes.
from where the sig
Private data specifier
: Data that the receiver uses to properly identify
the LCN value.
Manual NIT version
: Version of Network Information Table. Left empty
for automatic version.
Input
: Select the SAT input (from 1 to 4) to select services. Click on
“Change selection” to change the input SAT.
the selected
transport stream. User can select services by clicking on “Change
selection” button.
If the user wants the same settings at all IPTV outputs, just check and fill the
fields on the right side and click on “Use for all outputs”.
Generated services
: It shows services generated from
18
June 2021
