USER’S MANUAL. OS-782
Page 41
02-2010
En
g
lis
h
6.
Press and hold the
OSC OPTION
key till
▲
/
▼
CURSOR V2
appears on the
screen. Now, adjust the
OSC
▲
or
OSC
▼
and you can observe the dashed
line
V2
moving up and down while the measured voltage value of
V2
relative
to the zero position of CH1 is displayed on the screen. Also, the absolute
values of
V1
and
V2
can be shown on the screen.
Figure 24:
Use the cursor for a voltage measurement.
To use the cursor for a time measurement on
CH1
, do the following:
1. Press
the
MENU
key and the function menus are displayed at the right of the
screen.
2.
Press the “
MENU
▲
” or “
MENU
▼
” key to select
Cursor measurement
key.
Two key labels selectable are shown at the bottom of the screen.
3. Press
the
F1
key to the measurement type
Time.
Two vertical dashed lines
T1 and T2 appear on the screen.
4. Press
the
F2
key and jump to the measured channel
CH1
.
5.-
Press and hold the
OSC OPTION
key till the
▲
/
▼
CURSOR T1
appears on
the screen. Then, adjust the
OSC
▲
or
OSC
▼
and you can observe the
dashed line moving left and right. At the same time, the time value of
T1
relative to the
screen middle point position
will be displayed on the screen.
6.- Keep pressing on the
OSC OPTION
key till the
▲
/
▼
CURSOR T2
is
displayed on the screen. Then, adjust the
OSC
▲
or
OSC
▼
and you can find
that the dashed line
T2
is moving right and left while the time value of
T1
relative to the
screen middle point position
appears on the screen. You can
also observe the absolute time values and frequencies of
T1
and
T2.
Now,
you can see a screen that looks like the following figure 25.
