USER’S MANUAL. OS-782
Page 51
02-2010
En
g
lis
h
5.4
Making Multimeter Measurements
Press
DMM/OSC key,
the oscilloscope will switch to the multimeter measure, the
screen will display the multimeter windows, at the same time, prompt to correctly insert
testing pen of the multimeter, at this time, then press any key to enter into multimeter
measure.
5.4.1 Measuring Resistance Values
To measure a resistance, do the following:
1.
Press
the
R
key and
R
appears at the top of the screen.
2.
Insert the black lead into the
COM
banana jack input and the red lead into the
V/
Ω
banana jack input.
3.
Connect the red and black test leads to the resistor. The resistor value
readings are shown on the screen in Ohm. Now, you can see a screen that
looks like the following figure 34.
Figure 34.-
Measure resístance.
5.4.2 Making a Diode Measurement.
To make a measurement on the diode, do the following:
1.
Press
the
R
key and
R
appears at the top of the screen.
2.
Press
AUTO SET
key once and the following is displayed on the screen
.
