June 2016
Page 3
2.2
Install the Batteries
The multimeter is powered by two 1.5 V AA alkaline
batteries (not included).
WARNING
:
To avoid false readings, which
could lead to possible electric
shock or personal injury, replace
the battery as soon as the low
battery indicator
appears.
Before replacing the battery, turn
off the meter, disconnect test
leads and any connectors from
any circuit under test, remove test
leads from the input terminals.
Use only the specified battery
type.
Use the following procedure to install the batteries.
Ensure that the rotary switch is at the
position.
Remove test leads and any connectors from the input
terminals.
Lift the tilt stand and loosen the screws with a suitable
Phillips screwdriver and remove the battery cover.
Observe the battery polarity indicated inside the
battery compartment, Insert the batteries.
Place the battery cover back in its original position
and tighten the screws.
