SATHUNTER USER’S MANUAL.
Page 16
09/2008
Figure below shows the display of
SATHUNTER
in detect mode. Among the
data shown, there is the voltage average supplied to the LNB and if it is being applied
the 22 kHz signal.
o
o
o
o
o
o
o
o
Active function
indicator.
Battery state.
Measured value of
the LNB voltage
22 KHz signal
(activated).
Maximum measured
power bar.
Real time power bar.
Percentage of the real
time power
Percentage of maximum
measured power.
1)DETECT
MAX POWER RATE: 41%
POWER RATE:
40%
::
USB
18
Figure 8.-
DETECT
function.
If no signal is detected, the display will show horizontal bars at minimum level
and the percentage of power rate at 0 %. There will not be either audible signal and it
will appear the message “
LNB NOT DETECTED
”
.
4.2.2 Satellite Identification (2 > IDENTIFY)
Once a satellite has been detected (by localising a power maximum), you
should check if the received signal corresponds to anyone of the memorised satellites.
Select the satellites identification function
2> IDENTIFY
by pressing key
[2].
The identification system is based on a database of satellites previously loaded
to the equipment. Consult the configuration sheet supplied with the instrument for
further information on satellites that the instrument can detect.
The instrument can memorise up to sixteen combinations of frequencies and
polarizations (16 test points). Frequency measurements are configurable by software.
They can be shown as a FR (intermediate frequency) or DL (Downlink frequency). The
number of active points (selectable) can be also configured. A greater or lesser number
of satellites can be identified depending on the number of active points and how many
you want to assign to each satellite. Therefore, for example, if we assign one frequency
and the two possible polarizations to each satellite (i.e. 2 points for each satellite) and
they are activated 14 points, the instrument will be able to identify a total amount of 7
satellites. See the configuration sheet delivered with the instrument for further
information. Each test point has a name up to 8 letters assigned to it. It will be shown on
the display when is selected.
Summary of Contents for SATHUNTER
