USER MANUAL //
ELEVATOR PB-440
Review 01/19
46
06
GENERAL MAINTENANCE
CLEANING
Keeping the equipment cleaned is essential to ensu-
re a good use and durability of the set. It is necessary
to make a periodical thorough cleaning, especially in
areas exposed to dirt that could suffer damages, such
as gears, connectors, switches, etc. Do not use hi-
gh-pressure cleaning, they can damage the electrical
elements.
CONTROLS AND SELECTORS
Due to a heavy and continued use of the moving parts,
such as controls and selectors, check them periodica-
lly for a proper functioning. There may be failures on
micro-switches and cabling; examine the fixations and
electric or mechanical connections that could exist.
GREASE
Generally, every moving part should be greased. Our
products leave the factory completely greased and lu-
bricated, however, it is possible that with the time and
usage of the product the elements degrease, either by
loss of lubrication or by dirt. Clean and grease periodi-
cally the affected zones according to the manufactu-
rer’s specifications.
Verify that there are no loose, worn, or missing parts.
Examine periodically every moving element to ensure
that they are all tighten.
Do not grease the platform guide because of its sliding
dry system.
WARNING: Do not lubricate the bench once connected
to the electricity network.
WEAR AREAS
Regularly examining the system’s components to
check if they are wearing out is a preventive measure
that can reduce breakdowns. Verify possible lubricate
leaks, grooves or bearings in poor condition.
MECHANICAL FIXING
Generally we call mechanical fixing to the components
that are used to attach joint products, mainly screws
and derivatives.
In some conditions of use, due to vibrations or impacts,
many elements could lose their tightening torque or
hold properties.
Periodically examine that no elements are unleashed,
especially in the moving parts of the set. Take into ac-
count and always respect the recommended tighte-
ning torques.
REPLACEMENT OF COMPONENTS
This instruction manual doesn’t include procedures for
every part. The service staff typically substitutes cables,
commutators and certain mechanical parts without
any step by step procedure.
The qualified service personnel must contact our com-
mercial department for information about ordering
pieces and its installation.
MAKE SURE TO KEEP THESE AREAS FREE OF WATER AND HUMIDITY.
TAKE SPECIAL CARE NOT TO WET THEM WHILE WASHING THE SET.
Summary of Contents for PB-440
