Maintenance manual Universal-1000
P R O M E T A L
66
Wear ledges and impact bars
Check the thickness of the wear ledges weekly (every 50h) - minimum = 15mm (~ 0.600
”
)
We recommend changing the wear ledges at a thickness from < 17mm (0.670
”
)! But atleast at
a thickness of 15 mm (0.590
”
) the wear ledges must be changed, otherwise the heads of the
fixation screws will be worn so much, that they can not be removed anymore!
Remove possible paint from the bearing surface, when changing them!
Check weekly (every 50hours) distance and parallelism between wear ledges and the impact
bars. But at least at every mold change!
The right height distance between wear ledges and impact bars must be maintained!
The parallelism over the total surface is
very
important!
Summary of Contents for UNIVERSAL 1000
