Maintenance manual Universal-1000
P R O M E T A L
81
Table plate lifter
Check and clean
daily
(
based on a 1-shift operation
) the condition of the table plates it can
not be avoided, that a certain wear on the table plate will appear. You may turn the table plate,
if the front is worn too much!
-Table plate clamping-
Check
weekly
(
every 50 hours
) the tight fit of the fixation screws from the table plate
clamping!
-Table plate adjusting-
On every side are two (2) adjusting screws for the alignment of the table plate. They are
secured with a lock nut. You can adjust the table plate as follows:
-
open first the lock nuts
-
open all lock nuts; on both sides - in front and back
Turn the adjusting screws in the desired direction:
•
to the right - to adjust the table plate up
•
to the left - to adjust the table plate down
Summary of Contents for UNIVERSAL 1000
