The following data is stored:
n
Name of the measuring channel
n
Measured variable
n
Time of calibration
n
Zero point
n
Slope
You can also delete entries in the Calibration log book. Deleting
the entries does not affect the calibrations stored in the controller.
8.1.2 Reading the
[Error Log Book]
The error message data is stored in the
[Error log book]. Up to 30
error messages can be stored. Thereafter the oldest entry is over‐
written with the most recent entry.
Error log book
Entry
A1161
9.1.2.1.1
Error
Status
Goes
Channel 2
The connection to the
expansion module
is faulty
Fig. 30: [Error log book]
You can also delete entries in the Error log book. Deleting the
entries does not affect the errors stored in the controller.
8.2 Displaying
[simulation]
Continuous display ➨ ➨ or
[Diagnostics] ➨
[Diagnostics] ➨ or [Simulation] [Simulation]
WARNING!
Uncontrolled response
Cause: A controller operates uncontrolled in
[Simulation] mode under full load and thus so do
the connected actuators.
Possible consequence: Fatal or very serious inju‐
ries
Measure: Never leave a controller and its installed
functional modules unsupervised if the simulation
function is active.
Deleting entries in
the
[Calibration log book]
Deleting entries in the
[Error log book]
[Diagnostics]
46
