SmartStor NS4300N Product Manual
120
5.
Click the
OK
button.
6.
In the confirmation box, click the
OK
button.
Upgrading the System Firmware
See “Upgrading the Firmware” on page 163.
Enabling and Disabling the Buzzer
The SmartStor has a buzzer that sounds when the SmartStor is finished booting
and when a problem is detected. The buzzer is enabled by default.
Promise recommends that you leave the buzzer enabled.
To disable the buzzer:
1.
In the Tree, click the
+
beside the
Management
icon.
2.
Click the
Buzzer
icon.
3.
Click the
Disable
option button.
4.
Click the
OK
button.
5.
In the confirmation box, click the
OK
button.
Click the
Enable
option button, then click the
OK
button to enable the buzzer,
then click the
OK
button in the confirmation box.
Viewing UPS Status
If you have an APC Uninterruptable Power Supply (UPS) attached to the
SmartStor, you can check its status in PASM.
To view UPS status:
1.
In the Tree, click the
+
beside the
Management
icon.
2.
Click the
APC UPS
icon.
The Information tab displays the status of the UPS.
If there is no UPS connected or recognized, the Status field reports
“NO UPS.”
