Enable sensor output in CLI
To enable the alarm connected to the sensor device, that is, to enable the ability of the terminal
board send a signal to the alarm when the sensor device is triggered, follow these steps:
1.
Open the CLI interface, type
<enclosure –a mod –s “alarmstatus=1”>
2.
To check the Alarm Status, type
<enclosure -v>
Change the Alarm Status to enable or disable the connected external alarm device.
See “FAQ” on page 14 for more information.
9
IO Terminal Board User Information
Summary of Contents for Vess A2000 Series
Page 18: ......