Connecting an Analog Cameras with RS-232/422/485 ports
These are important points to keep in mind when using or connecting and using analog cameras.
• Only one connector can be used at one time:
RS-232C
,
RS-422
, or
RS-485
•
For
pan
,
tilt
and
zoom
operations, connect a camera control cable to RS-232 connector or the
RS-422/485 connector (four rightmost pins on the alarm output connector).
• RS-232 Port 1
: This is used for control line connection to an uninterruptible power supply
(UPS).
• RS-232 Port 2
: Use this to connect to analog cameras via the analog camera input cable.
Note
: This connector cannot be used at the same time as the RS-422/485 connector.
• RS-422/RS-485
: Use this to connect to analog cameras via the analog camera input cable.
Note
: This connector cannot be used at the same time as the RS-232 connector.
11
IO Terminal Board User Information
Summary of Contents for Vess A2000 Series
Page 18: ......
