Task 3: Installing Disk Drives
11
3.
Insert the screws through the holes in the drive carrier and into the sides of
the disk drive.
•
Install only the counter-sink screws supplied with the VessJBOD.
•
Install four screws per drive.
•
Snug each screw. Be careful not to over-tighten.
4.
Reinstall the drive carrier into the VessJBOD enclosure.
Repeat steps 1 through 3 until all of your disk drives are installed.
Figure 11. Disk drive mounted in a drive carrier
This completes disk drive installation. Go to “Task 4: Making Data and
Management Connections” on page 12.
Caution
VessJBOD supports disk drive hot-swapping. To avoid hand
contact with an electrical hazard, do not remove more than one
drive carrier a time.
Disk drive
mounting screw
mounting screw
