10G NAS Client network setup Link Aggregation Option 2
1G Management link cable arrangement for Link Aggregation Option 2
For this option, only one 1G LAN port (Port 1) on all units must be connected to the Gigabit Ethernet switch
for the Management link to the VTrak A-Class. The remaining 1G LAN ports are used for the NAS Client link.
To connect the 1G ports, follow these steps:
1. Attach Category 6 or better Ethernet cables to all ports 1 Gigabit Ethernet ports on the rear panel of all
G1000 devices.
2. Attach the other end of the cables to a 1 Gigabit Ethernet switch.
10G NAS Client cable arrangement for Link Aggregation Option 2
Complete the cable connections for a 10 Gigabit LAN data network if you plan to use the 10G LAN for data
connection to NAS clients. The 10G cabling for the NAS Client link is identical to that used for Option 1.
To connect to the 10 Gigabit Ethernet LAN, follow these steps:
1. Attach Category 7 (recommended) or Category 6 Ethernet cables to both 10 Gigabit Ethernet ports on the
rear panel of all G1000 devices.
2. Attach the other end of the cables to the 10 Gigabit Ethernet switch used for the NAS Client network.
20
VTrak G-Class Product Manual
Promise Technology
