Rail Safety Latch
Installing the Chassis
d.
Once the rails are mated properly, slide the enclosure into the rack until it is
stopped by the safety catch on the rails. Push the release lever on the safety latch
(located on the side of each of the rails), and push the enclosure the rest of the way
into the rack.
e. As the chassis is slid into the rack,
position one installer at the rear of the rack
to ensure that the pegs on the sides of the
cover will slide correctly into the rear cover
alignment brackets on both sides of the rack. If
the chassis does not install smoothly or snags,
check that the rear cover alignment brackets
are not interfering with the chassis sidewalls,
and try again.
b.
In preparation to perform a team lift, position one individual on each side of the
enclosure (to lift) and a third individual standing at the protruding rack rails (to guide
the chassis to mate with rack rails).
c.
Team-lift the enclosure until the inner rails (which are attached to the chassis)
align with the extended mid-rails (which are attached to the rack), and guide the inner
rails on the chassis to mate with the rack rails.
14
Promise Technology
VTrak J5960 Quick Start Guide
