Promix-SM102
8
See operating voltage range in 5.2. Avoid supply of overvoltage.
Lock mounting on a sliding door of a rolling door cabinet.
1.
Mount the lock on an immobile surface.
2.
Fix the lock on the cabinet wall (as shown in Fig.). For a NO lock, make a mark
on the door at a distance of 45 mm (49 mm for NC) from the cabinet wall along the lock
axis. Pin the marking template on the mark obtained (see p. 7) and mark the fastening
holes.
3.
Assemble the latch on the angular bracket in accordance with the Fig. (see p. 5) and
fasten it to the door.
4.
Adjust the latch position so that the distance from the bracket edge to the cabinet wall
is 50-51mm for a NO lock (54-55mm for NC).
6.2
CONNECTING PROCEDURE
The lock operation is controlled by means of energizing and de-energizing. For this purpose, a
controller (control board) or a switch (button) is generally used. The controller is mounted in
accordance with its certificate.
Connect the lock power wires adhering to the following polarity:
Red (black with a red stripe)
– positive pole of the power supply;
Black
– negative pole of the power supply;
Application of voltage of reverse polarity does not provide the lock operability but does cause
its failure.
Connect sensor leads:
Colored wires (yellow, green, etc.)
– door position sensor output.
Example of the lock connection to the remote control system Promix-RDS.
Lock
Controller Promix-CR.RX
Remote control
Promix-CR.TX
220 V
Cabinet wall
Cabinet door
For NO
( 54-55 For NC)
