Promix-SM213
9
It is prohibited to use silicone grease and WD-40.
The warranted operation period is 12 months from the date of sale but not
longer than 18 months from the day of acceptance by the manufacturer’s QCD.
Faulty products are accepted for repair only together with the latch, on the
obligatory condition that factory labels are retained on the product body.
Then sink the catch and lubricate inner walls of the body on the side of the catch. Replace the
protective film removed earlier, and mount the lock on the door.
10.
STORAGE AND TRANSPORTATION
Until putting into operation, the locks must be stored in the manufacturer’s packing, in rooms
with an ambient temperature
of -
30 to +50 °С
and a relative humidity not higher than 98% at 25º
С in compliance with storage conditions as per GOST 15150-69.
Locks transportation conditions must comply with group C as per GOST 23216-78 in terms of
exposure to mechanical factors, and Ж2 as per GOST 15150-69 in terms of exposure to climatic
factors.
11.
SAFETY REQUIREMENTS
The design of the locks ensures safety of personnel involved in mounting and maintenance.
Due to low DC supply voltage, the products correspond to class III as per ГОСТ 12.2.007.0-
75 and are electrically safe.
Fire safety of the locks is ensured by use of non-combustible or hardly combustible materials,
and low supply voltage.
12.
DISPOSAL
The product is not hazardous for human life and health or for the environment; disposal after
its service life is performed without taking any special measures for environment protection.
13.
WARRANTY LIABILITIES
The manufacturer, ETC PROMIX LLC, warrants conformity of Promix-SM213 locks to
requirements of current Technical Specifications provided that transportation, storage, installation
and operation rules established in this Manual are followed.
Within the period of warranty, ETC PROMIX LLC undertakes to repair defective products free
of charge. Expenses for transporting the product to the place of repair and back will be borne by
the Buyer.
Warranty liabilities do not cover any defects and damages caused by:
Improper maintenance by the Buyer;
Use of the product under conditions that do not comply with the operation requirements;
Mechanical damages or disassembly of the products by the Buyer;
Non-observance of the transportation and storage rules.
On expiration of the warranty service period, the manufacturer provides after-warranty service
on a contractual basis.
