6
9.
MAINTENANCE
The controller: special maintenance is not required.
The remote control: if the LED does not light up or glows dimly it is necessary to replace the
battery of the remote control. To replace the battery, unscrew the screw on the back of the remote
control and disassemble the body.
10.
REQUIREMENTS OF SAFETY AND
ENVIRONMENTAL ENGINEERING
Promix-RDS set meets the safety requirements as per GOST R IEC 60065-2009.
Installation and operation of the controller Promix-CR.RX.03 must meet the safety
requirements as per GOST 12.2.003-91.
The controller Promix-CR.RX.02 meets the fire safety requirements as per GOST 12.1.004-91.
Promix-RDS.01 set is not hazardous for life and health of people and for environment. After the
expiration of the service life, the set can be disposed of without any special environmental
protection measures.
10.1 ELECTRICAL SAFETY REQUIREMENTS
Due to low supply voltage the remote control Promix-CR.TX.01 is electrically safe.
Electrical safety requirements for the controllers Promix-CR.RX.02 meet the requirements of
protection against electric shock according to class II as per GOST R IEC 60065-2009.
The insulation strength between the current-carrying circuits of the mains supply and the
secondary circuits with a low-voltage complete device must withstand an AC voltage of 3750V of
practically sinusoidal form with a frequency of 50±1 Hz. The electrical insulation resistance
between the current-carrying circuits of the mains supply and the secondary circuits, depending on
the climatic operating conditions, must be at least of the following values:
- with a low-voltage complete device - 10 MOhm;
- at the highest value of temperature - 4 MOhm;
- at the highest value of relative humidit
y (98% at 25°С)
- 1 MOhm.
The residual voltage between the pole contacts of the power cord must not exceed 31V one
second after disconnecting from the power grid.
In the controller Promix-CR.RX.02 there are no circuits that lead to leakage currents.
11.
STORAGE AND TRANSPORTATION
Prior to putting into operation, the products must be stored in the manufacturer’s packing, in
rooms with ambient air temperature of -30 to +50
°С and relative humidity not higher than 98% at
25 °С according to the storage condit
ions as per GOST 15150-69.
The products transportation conditions must comply with group C under GOST 23216-78 in
terms of exposure to mechanical factors, and Ж2 under GOST 15150
-69 in terms of exposure to
climatic factors.
