«
Network selection
»
-
to connect to the Wi-Fi network.
21
«
Testing
»
-
the transition to the test mode. In this mode it is possible to check the
operation of ultrasonic sensors, arms, head and eyes of the robot.
To check the condition of arms you need to press the
"Raise"
- the robot must raise the
proper arm.
To check the performance of the head and eyes, press the button
"Rotate"
- the robot
has to turn his head and display and show hearts.
Check ultrasonic sensors: Sensors are schematic circles with the numerical values
underneath. Color circles may be
red,
this means that the sensor is triggered, or
blue
– it
is not triggered.
The numerical value
indicates the distance from the sensor to the
obstacle in centimeters. In case of a fault of the sensor value will be "1", as shown in the
figure above. In case of correct operation when approaching or getting away from the
sensor, the numerical value must change to a smaller or larger respectively.
Robot
PROMOBOT v.2.0
