3.
4
End of work. Charging
After a day of work robot will alert you on low battery. It will change the expression of
eyes to the battery symbol, and will make an announcement about it using voice. In this
case, the robot needs to be transported to a storage location and connected to a charger.
To do this, go to the robot, and then take the following steps:
1.
Turn on the joystick and go to manual mode;
2.
The need to hold down the key 2 for transporting the robot, and then use the left
stick, to make transportation to the place of work;
3.
Press the button switching off the robot;
4.
Insert the charger cable into the port.
џ
Recharging takes place only when the robot is switched off. If the
robot is switched on, the indicator will be glowing red, but the
battery will not be charged!
2
7
3.5
Transportation
For safe transportation of the robot you must unplug its power supply by switching off
(the switch is inside of the robot). This switch is located under the chassis in front of the
robot, on the right side of the bottom.
Robot
PROMOBOT v.2.0
