Rail Bull
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
13
Set
the pressing
lever to the position ON (
5
) to press the front rollers to the track.
Slide the carriage to the required position
(
6
), and fully
tighten
the
drive
clutch
knob
(
7
)
to
engage the gear wheel of the carriage with the gear rack of the track. Then, loosen
the knob by
1/4 rotation.
When operating at heights, protect the carriage and the track from falling. To do
this, fasten the track to a fixed structure with chains attached to the leftmost and
rightmost dual magnetic units. Protect the carriage by attaching a chain to a carrying
handle. The chains (not included) must not be loose.
Plug the power cord
into
the power source, and
then insert
the torch into the torch
holder and
secure
with the
knob.
Next, insert the torch cable into the cable anchor,
secure with knobs, and then fix the anchor in the required position with levers.
3.4. Connecting to the welding or plasma cutting circuits
The
carriage
can
control
two
torches
by
using
the arc ignition cable plugged into the arc
ignition
socket.
To
do
this,
connect
any
blue-jacketed wire to any terminal
of
the welding
/
plasma
cutting
circuit,
and then connect the second blue-jacketed wire to the second
terminal of the same circuit,
according
to
the
diagram
shown in
Fig.
7.
To control the
second torch, connect the green-jacketed wires to the terminals of the second circuit.
Fig. 7.
Connecting the arc ignition cable to welding / plasma cutting circuits
To make sure that the
arc
ignition
cable
is
connected
correctly, turn on the power
of the carriage, and set
the arc ignition
switch
to the position TEST, which should
enable the arc for a while.
blue
blue
Circuit 1
g
re
e
n
g
re
e
n
Circuit 2
