Rail Bull
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
7
2. SAFETY PRECAUTIONS
1. Before beginning
, read this Operator’s Manual and complete proper occupational
safety and health training.
2.
Use the carriage only in applications specified in this Operator’s Manual.
3. The
carriage must
be
complete
and
all parts must be genuine and fully operational.
4. The
specifications of the power source
must
conform
to
those
specified
on
the
rating plate.
5. Connect the carriage into a properly grounded power source.
6. Never carry the carriage by the cords or arc ignition cable and never pull them as
this may damage them and result in electric shock.
7. Untrained bystanders must not be present near the carriage.
8. Before
beginning,
make
sure that the correct is the condition of the carriage, power
source,
cords,
arc
ignition
cable,
plugs,
control
panel,
guiding
rollers,
and gear wheel.
9. Keep the carriage dry. Exposure to rain, snow, or frost is prohibited.
10. Keep the work area well lit, clean, and free of obstacles.
11. Never use near flammable liquids or gases, or in explosive environments.
12. Transport and position the carriage by using the carrying handles.
13. Install the carriage only on the supplied track.
14. Make sure that the gear wheel and guiding rollers are clean and not damaged.
15. Plug the cords and arc ignition cable into sockets only when the power switch is
set to the
position ‘O’.
16. Keep the sockets clean. Do not use compressed air for cleaning.
17. Install only MIG/MAG welding torches or
oxy-fuel/plasma
cutting
torches with the
handle diameter corresponding to the torch holder in use.
18. Suspend cables to reduce the load of the carriage.
19. Do not bend the semi-flexible track to a radius less than 5 m (16 ft).
20. Use the rigid track only on flat surfaces.
21. When operating at heights, protect the carriage and the track from falling. To do
this, fasten the track to a fixed structure with chains attached to the leftmost and
rightmost dual magnetic units. Protect the carriage by attaching a chain to a
carrying handle. The chains must not be loose.
22. Do not stay below the carriage or the track placed at heights.
