The spring loaded pin locks into camera
hole to keep camera from rotating.
Rotate camera until this locks in place.
Turn the camera knob to secure camera.
Loosen slightly to adjust camera position.
When camera is in position turn knob to lock
into place. Do not over tighten.
ce
.
USING DUAL HEIGHT RISER
The dual height camera riser is used with
smaller cameras. To attach simply pla
riser on camera mounting block and
tighten the camera block knob. Loosen
slightly to adjust camera position
The camera thumbscrew
can be removed from
one end and attached to
the other side.
NOTE:
Full sized cameras
do not require dual
height riser.
3
Revised 042009
STEP 3 - ATTACH CAMERA TO TELEPROMPTER
The Flex 15/17/19 offers multiple methods for attaching your video camera. Larger cameras attach directly to the
camera mounting block. Smaller cameras mount on the included dual height camera riser that attaches to the
camera mounting block. The dual height camera riser also allows cameras with short or flush mounted lenses to get
closer to the teleprompter mirror for optimum performance.
PLACE CAMERA ON SLED
The camera should be mounted with it’s lens vertically centered
in the beamsplitter. Choose the side of the riser that puts the
camera in this position. Secure camera to riser with attached
camera screw. When camera is mounted slide it gently forward
until lens is one inch behind glass beamsplitter. Rotate red knob
in “lock” direction to secure camera in place.
After camera is positioned properly, pull lens hood
over lens and secure with drawstring. Make sure hood
is not in front of lens. Note dual height is turned in this
picture is turned to accomodate different sized camera.
