PRONIVO PNRLG-1D, User Manual

23

Buttons and LEDs

1 – Power Button – On/Off and activating rotary beams

2 – Button for slope and clockwise beam rotation in scanning mode

3 – Button for slope and counterclockwise beam rotation in scanning 

mode

4 – Button for manual or automatic mode

5 – Button for scanning/rotation speed

Usage

1) Press once the power button (1), to switch the instrument on. The MODE 

LED flashes green. The horizontal line is activated. After leveling the 

MODE LED is permanently green and the rotation starts. If the instrument 

is not able to level, the red LED flashes quickly. Re-position the rotary laser 

in a more horizontal way. Pressing the power button again activates the 

additional lines (according to model H/V/HV/HVV). ADS is active after 

60 seconds.

2) Press the button (4) once to switch off ADS. Press it again to switch 

to the manual mode. The red ALARM LED is on. By pressing the button 

(4) again, the instrument goes back to the automatic mode.

3) In manual mode press the buttons (2) and (3) to slope the laser re-

ference. (2) inclines the X axis upwards. (3) inclindes the X axis down-

wards.

4) Press the button (5) several times to change the rotation speed 

(1000/2000 and 600 rotations per minute). For usage with a laser de-

tector, please select 1000 or 2000. Press the button (5) long to switch 

to the scanning mode. This function is only available for the horizontal 

beam. You can rotate the scanner beam with the buttons (2) and (3) .

MODE

MODE

TouchPad for PNRL3D & 2D

2015-12-31 Rev.F

Power/Control switch

Short press to switch rotation laser motor

H/V/HV/HVV  (PNRL-3D)

H/V/HV          (PNRL-2D)

Press and hold 3 seconds to turn unit off

Slow flashing

Flashing

Steady light

Movement leveling

Automatic level work

Green: battery with sufficient
Red: low battery (<4.4V)

Over level renge

Speed switch

Control rotation speed or scan angle

when the corresponding mode is on

Short press to switching speed cycle

1000/400/2000 rpm (Rotation mode)

Short press to switching scan angle

10

°

/45

°

/90

°

 (Scan mode)

Long press to switch between rotation mode

and scan mode (Only H or V runtime can

switch to scan mode)

Manual mode button

X-axis tilt upward

X-axis tilt down

ALARM

Steady light

Manual mode

ALARM

Scan CWW

Scan CW

MODE

ALARM

SPEED

SPEED

Scanning/ 

Rotation 

speed(5)

Clockwise 

rotation

Arrow up (2)

On-/Off (1)

Counterclock-

wise rotation

Arrow down (3)

Manual

mode (4)