SECTION 8—FOOTBOARD ASSEMBLY
48
SECTION 8—FOOTBOARD
ASSEMBLY
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited Clearance Between Footboard and Caster - The user’s feet MUST remain
on the footboard while operating the chair. If the user’s feet are allowed to rest off
the side of the footboard they may come in contact with the caster possibly result-
ing in injury.
Removing/Installing the Footboard Assembly
WARNING
Pinch point may occur when rotating the footboard assembly.
NOTE: For this procedure, refer to FIGURE 8.1.
Removing
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.
Installing
WARNING
Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
