SECTION 9—FRONT RIGGINGS
56
Adjusting Legrest Length
WARNING
Before and during use of the wheelchair, ensure that there is adequate distance
between the legrests and the front casters or the ground. Incorrect adjustment of
the legrests may cause bodily injury.
NOTE: For this procedure, refer to
FIGURE 9.5.
NOTE: This procedure requires a 1 x 6 mm
Allen wrench.
1. Use the Allen wrench to loosen the
adjustment screw.
2. Adjust to the desired length.
3. Re-tighten the screw.
FIGURE 9.5
Adjusting Calf Plate Depth
NOTE: For this procedure, refer to FIGURE 9.6.
NOTE: This procedure requires a 1 x 10 mm open-ended wrench.
The depth of the calf plate can be adjusted via the holding plate. The holding plate hole
combinations allow five different depth settings.
1. Use the open-ended wrench to loosen and remove the locknut.
2. Adjust to the desired depth.
NOTE: Only the round holes are used for adjusting the calf plate depth. Do not use the oblong holes
to set the calf plate depth.
3. Install the locknut and securely tighten.
Adjustment Screw
